AT Commands Reference Manual - wireless netcontrol GmbH

Chapter 3: AT Commands Reference
Table 3-155: +MFOTAIND Parameters (Cont.)
Description
10 Idle/Start - No pending operation.
20 Download Failed.
30 Download has started.
40 Download complete - Successfully.
50 Ready to Update - Have data and awaiting command to start update.
60 Update progressing - update has started.
70 Update Failed / Have Data - Update failed but have update package.
80 Update Failed / No Data - Update failed and no update package available.
90 Update Successful / Have Data - Update complete and data still available.
100 Update Successful / No Data - Data deleted or removed after a successful
Update.
5 DM Session started.
6 DM session in progress.
7 DM Session completed.
8 xx DM session interrupted, xx (fail reason see Table 3-156).
9 Unable to connect to server.
10 Bootstrap completed.
11 Access failed.
12,xx Download failed, xx (fail reason see Table 3-156).
13,xx Software update xx% completed.
14 Download in progress.
15 SW download completed.
16 SW update complete.
17 SW update failed.
18 No update package available.
19 SW installation has started.
The following table shows the failure reasons.
Table 3-156: Failure Reasons
Failure
Reason
0 Success.
16 Unspecific error.
17 Memory error.
18 Not allowed or bad parameters.
19 Attempt to call TRG_RDM_run with non-resume trigger when suspended.
32 SyncML message Protocol or version error.
8194 Workspace buffer too small.
24576 Buffer overflow.
24577 Badly formatted input.
24578 Tree node already exists.
24579 Tree node is missing.
April 15, 2010 H24 - AT Commands Reference Manual 3-235