AT Commands Reference Manual - wireless netcontrol GmbH

Chapter 3: AT Commands Reference
Application Level Location Request and Report
+MGPSLOC, Location Request and Report
Two location request application types are supported:
• Single shot fix information
• GPS Tracking
The Execute command supports single shot fix information; upon issuing of the command, H24
attempts a single position fix and replies with the fix information once fix is achieved.
The Set command enables and configures the H24 to report constant unsolicited position
messages, i.e. GPS tracking.
Position information structure is similar for tracking and single shot fix. For QoS dependency see
See “+MGPSQOS, Set QoS Parameters”.
Command Type Syntax Response/Action Remarks
Set
AT+MGPSLOC=[],[
],[]
OK
or:
+CME ERROR:
Set command
controls the
presentation
of an unsolicited
result code
+MGPSLOC:
When =1
and valid position
is available
+MGPLOC:
,,<
Position>,,,,.
When valid
position is not
available or QoS
was not reached
+MGPLOC:
0,0,0,0,0,0,0
see also
AT+MGPSQOS.
Execute AT+MGPSLOC +MGPSLOC:
,,,,,,
OK
or:
+CME ERROR:
When valid
position is not
available or QoS
threshold in
meters is not
reached within
approximately 4.5
Minutes
+MGPLOC:
0,0,0,0,0,0,0 is
returned
see also
AT+MGPSQOS
April 15, 2010 H24 - AT Commands Reference Manual 3-361