AT Commands Reference Manual - wireless netcontrol GmbH

AT Commands Alphabetical Summary
+FRS
+FTH
+FTM
This command causes the H24 to wait for silence and to report back
an OK result code when silence has been present on the line for the
specified amount of time.
This command causes the H24 to transmit data framed in the HDLC
protocol, using the modulation mode selected, to the remote party.
This command causes the H24 to transmit data to the remote party
using the modulation selected in .
Page 3-59
Page 3-62
Page 3-60
+FTS This command causes the H24 to stop any transmission. Page 3-59
+GMI This command displays manufacturer identification. Page 3-1
+GMM This command displays the model identification. Page 3-2
+GMR This command displays the revision identification. Page 3-3
+GSN This command requests the product serial number identification. Page 3-3
+ICF
+IFC
+IPR
This command determines the local serial port start/stop
(asynchronous) character framing used by the DCE when accepting
DTE commands and transmitting information text and result codes.
This parameter controls the operation of the local flow control
between the terminal and the H24 during the data state when V.42
error control is used, or when fallback to non- error control mode is
specified to include buffering and flow control.
This command is responsible for setting and saving the request baud
rate.
Page 3-168
Page 3-169
Page 3-158
+MACRXG Sets Codec RX gain of the active audio mode. Page 3-201
+MACSTG Sets Codec ST gain of the active audio mode. Page 3-202
+MACTXG Sets Codec TX gain of the active audio mode. Page 3-202
+MAEC Selects EC type. Page 3-206
+MAFRST
+MAGRST
+MAHSD
Table A-1: AT Commands (Alphabetical) (Cont.)
AT Command Description Page
An action command to restore manufacturer's audio features
defaults.
An action command that restores manufacturer's default RX, TX
and ST gain values for all audio modes.
This command Enables/disables the headset switch detect
mechanism.
Page 3-207
Page 3-206
Page 3-205
+MAMOD This command selects the active audio mode. Page 3-203
+MANS This command enables/disables NS for the active audio mode. Page 3-208
+MAST This command enables/disables sidetone for the active audio mode. Page 3-208
+MATXV This command sets uplink (microphone) volume. Page 3-209
+MBAND
This command configures the RF bands that the unit will use for
communicating with the Network.
Page 3-141
A-6 H24 - AT Commands Reference Manual April 15, 2010