AT Commands Reference Manual - wireless netcontrol GmbH

Chapter 3: AT Commands Reference
Table 3-18: +CBST Settings in WCDMA Mode (Cont.)
+CBST Command
Protocol
* WAIUR
Air bit rate
[Kbps]
** FNUR
Air bit rate
[Kbps]
Attributes
Comments
AT+CBST=83,x,1 X.31 FS 57.6 56 Nontransparent
asynchronous
Frame Tunneling mode
x:0=UDI, 4=RDI.
AT+CBST=84,0,1 X.31 FS 57.6 64 Frame Tunneling mode.
AT+CBST=116,1,0 Undef 64 Transparent
synchronous
AT+CBST=134,1,0 H.223/H.245 Undef 64 Transparent
synchronous
***UDI
Multimedia UDI
Note: * WAIUR - Wanted Air Interface User Rate.
At the call setup the mobile station sends a set of parameters describing the characteristics
to the network.
** FNUR - Fixed Network User Rate.
One of WAIUR parameters and represents the Fixed Network User Rate. It is the user rate
between IWF (InterWorking Function) and the fixed network.
*** UDI - Unified Display Interface.
Example
AT+CBST=?
+CBST: (0,7,12,14,16,17,39,43,48,51,71,75,80,81,83,84,116,134),(0,1,4),(0,1)
OK
AT+CBST?
+CBST: 14,0,1
OK
AT+CBST=17
OK
AT+CBST?
+CBST: 17,0,1
OK
O, Return to Online Data State
This command returns the H24 from the Command mode to the Online Data mode and issues a
CONNECT or CONNECT result code.
After dialing or answering (atd/ata commands and connect), the phone enters the Online Data
mode where it is able to transfer data, but not to enter AT commands.
April 15, 2010 H24 - AT Commands Reference Manual 3-39