AT Commands Reference Manual - wireless netcontrol GmbH

Chapter 3: AT Commands Reference
The following table shows the Qn parameters.
Table 3-159: Qn Parameters
Description
0 Transmit result codes.
1 Suppress result codes.
The default value is 0.
Example
ATQ0
OK
ATQ?
Q: 0
OK
ATQ4
ERROR
ATQ1
ATQ4
//No response because result codes are suppressed.
//No response because result codes are suppressed.
E, Command Echo
This command defines whether input characters are echoed to output. If so, these characters are
echoed at the same rate, parity and format at which they were received.
Command Type Syntax Response/Action Remarks
Set ATE OK
or:
+CME ERROR:
The Set command sets whether or not
to echo characters.
Read ATE? The Read command reads the current
setting for command echo.
Test
The Test command for E is not defined
by ITU, and therefore is not supported
by the H24. The H24 returns an error.
The following table shows the E parameters.
Table 3-160: En Parameters
Description
0 Does not echo characters
1 Echoes characters
The default value is 0.
April 15, 2010 H24 - AT Commands Reference Manual 3-241