AT Commands Reference Manual - wireless netcontrol GmbH

Chapter 1: Product Features
Network
Network Commands
+CSQ This command displays the signal strength received by the H24. Page 3-126
+CRLP This command displays the Radio Link Protocol parameters. Page 3-127
+CREG
+CGREG
+COPS
This command enables/disables the network status registration
unsolicited result code.
This command enables/disables the GPRS network status
registration unsolicited result code.
This command enables accessing the network registration
information, as well as select and register the GSM network
operator.
Page 3-128
Page 3-130
Page 3-133
+COPN This command returns the list of operator names from the H24. Page 3-136
+CPOL
Table 1-1: AT Commands (Cont.)
AT Command Description Page
This command is used to edit the list of preferred operators located
in the SIM card.
Page 3-138
+CPLS This command is used to select PLMN list in the SIM/USIM. Page 3-140
+MBAND
+MCI
+MCICFG
+WS46
+MPDS
+PACSP
+MLOPS
This command configures the RF bands that the unit will use for
communicating with the Network.
This command reports to TE information of a current serving cell
and neighbor cells.
This command Enables/Disables Motorola Cell Information process
(cell data gathering on background and MCI request).
This command is used to query the current cellular network (Access
Technology selected).
This command indicates current available type of Packet Data
Service.
This command shows the Network Selection Menu
availability.
This command enables/disables LOPS (Limited Operator
Selection) feature, while USIM/SIM is not inserted.
Page 3-141
Page 3-144
Page 3-148
Page 3-150
Page 3-151
Page 3-152
Page 3-152
Hardware Information
Hardware Information Commands
+CBC This command queries the battery charger connection. Page 3-156
+CBAUD This command sets the baud rate. Page 3-157
+IPR
This command is responsible for setting and saving the request baud
rate.
Page 3-158
&K This command configures the RTS/CTS flow control. Page 3-160
&C
This command determines how the state of the DCD line relates to
the detection of the received line signal from the distant end.
Page 3-161
April 15, 2010 H24 - AT Commands Reference Manual 1-23