Manual

Manual – TopCon TC.GSS
CAUTION
Possible damage!
Installation and commissioning
Installation
Due to soiling and foreign bodies at the installation location.
Due to a build-up of heat.
Avoidance:
The installation location must be free of conductive and
aggressive substances as well as moisture.
No foreign bodies such as drilling swarf or screws are to
be allowed to fall into the system.
It imperative you observe the minimum distances during
installation.
The ventilation openings on the front panel and rear wall of
the devices must not be covered or sealed under any
circumstances.
Case installation/delivery with case
TopCon TC.GSS power supplies are installed in standard cases or
switch cabinets either separately or in multi-unit systems.
In the standard design TopCon TC.GSS power supplies are intended to
be installed in standard 19” cases and switch cabinets with an external
air flow. In this case they are to be placed on rails or shelves and fastened
at the points provided on the front panel.
Number of screws:
For 9 U devices typically: 6 x screws M6.
On installation in cases or switch cabinets, the following points are to be
noted:
Use robust rails or shelves (from the case/cabinet manufacturer):
the cases for TopCon TC.GSS power supplies must be in contact
over the full installation depth. At the rear a cross-member is
to be installed for additional fastening of the power supplies.
Suitable transport aids must be used for the installation and
removal of the power supplies. E. g. fit the carrying handles
supplied in the side walls of the power supplies.
The power supplies are to be lifted at these handles.
2011-10-18 106 / 298 V00.05b
6