Manual

Manual – TopCon TC.GSS
TopControl application
Tab –
tab – parameter overview
1
2
3
Sense voltage measurement, group
Calibration of the sense.
The maximum and minimum sense voltage is calibrated using the gain and
the offset.
The indication on the right shows the allocation between the actual measured
value and the sense voltage.
DC link voltage measurement, group
Calibration of the intermediate circuit voltage measured value.
The maximum and minimum intermediate circuit voltage is calibrated using
the gain and the offset.
The indication on the right shows the allocation between the actual measured
value and the sense voltage.
Store settings, button
Settings made on the tab are permanently saved. The actual
parameter set is saved from the RAM to the flash PROM in the TC.GSS power
supply.
Table 119 Overview of the tab.
2011-10-18 232 / 298 V00.05b
7