Manual

Manual – TopCon TC.GSS
TopControl application
Tab –
Creating user-defined functions
(“User defined Base Functions”)
“User-defined functions” are reference value functions in relation to the
time axis.
1 2
3
4
Fig. 111 Function generator - example of a user-defined function.
“Edit user defined Functions” window – parameters
1
2
3
time values, list box
relative: The time information for a point refers to the previous point.
absolute: The time information for a point refers to the start of the
curve.
The selection has an effect on the position of points, see , -9-
select Function Block..., list box
The list box contains the reference values that are selected in the “General
setup” group. See “Conditions for user-defined curves” Table 94, Seite 193.
edit Base Function, list
If the times specified are changed via the Time prescaler -8-, the time
information is recalculated accordingly.
The amplitude of the reference value remains constant.
Edit points by double-clicking the line using the left mouse button.
The table is continued on the next page.
2011-10-18 195 / 298 V00.05b
5
6
7
8
9
11
7
10