Manual

Manual – TopCon TC.GSS
Appendix
Error list
Group error: D) Configuration (continued)
Flashing
code
TopControl/HMI
indication
14-9 D8) All slave ID's
have to be
numbered
without a gap
14-10 D9) All HMI/RCU
ID's have to
be numbered
without a gap
14-11 DA) Number of
slaves does
correspond
with the giv-
en value
14-12 DB) Number of
multiload
modules
does not correspond
with
the given
value
14-13 DC) Invalid slave
ID (out of
range)
14-14 DD) Invalid
HMI/RCU ID
(out of range)
14-15 DE) TCLIN ID
invalid
14-16 DF) TCLIN ID not
unique
Description
The module IDs are
not sequential
The HMI IDs are not
sequential
Total number of devices
does not match
the data specified
Module ID for a slave
outside the valid range
HMI ID outside the
valid range
Master detecting
invalid TCLIN ID
Master detecting
several TCLIN with
same ID
Possible reason
Measure to rectify
10.2.2.15. Error group E) Not def.(group 14)
Group error: E) Not def.(group 14)
Flas
hing
code
TopControl/HMI
indication
Description
10
All module IDs must be sequential. For information
on the meaning of sequential, see multiunit
system chapter (for a parallel configuration,
sequential means e.g. ID [hexadecimal] = 00,
10, 20, ...)
The value 'uiCAN_MaxNumModuleParallel' must
be set identically in all modules. Default: 8.
All HMI IDs must be sequentially numbered
starting with 1.
See above, error D6/D7)
It is not possible to connect more than 8 devices
in series or on parallel
Configure the ID via the HMI.
Check IDs for the TCLIN individually / set
Check IDs for the TCLIN individually / set
Possible reason
Measure to rectify
Errors in group E) do not currently exist and are for further additions.
2011-10-18 293 / 298 V00.05b