Manual

Manual – TopCon TC.GSS
6.3.2.3. Device self-test
Installation and commissioning
Switching on and off a TopCon power supply
The duration of the device self-test is approx. 5 seconds.
In multi-unit operation the system is also configured and the communication
between the power supplies connected checked for correct function.
Self-test reports status: “OK”.
READY light emitting diode (green) illuminates continuously.
The device is ready.
State machine changes to the “READY” state.
For further information see chapter 4.3.5, page 50.
Self-test reports status: “Error”.
Error light emitting diode (red) illuminates or flashes.
Flashing code on the ERROR light emitting diode indicates the
reason for the error.
For further information see chapter 10.2, from Seite 275.
State machine changes to the “ERROR” state.
For further information see chapter 4.3.5, page 50.
If the state machine remains in the “ERROR” state after a
repeated start attempt, look for the reasons for the error using
the “TopControl” application and take the necessary corrective
measures.
Parameterisation
If possible do not make any changes to the factory settings, as the factory
settings take into account your needs, the operation foreseen and
your individual applications in the majority of cases.
If you nevertheless need to make application-specific settings, you can
make them using the TopControl application from your PC.
However, prior to changing the settings we recommend undertaking the
function test described in the following and only then changing the settings.
In particular for monitoring values, ramp functions or controller
settings.
2011-10-18 116 / 298 V00.05b
6