Manual

Manual – TopCon TC.GSS
Main screen – DISPLAY 1
1
Operation of the HMI (option)/RCU (option)
Main screen – DISPLAY 1
Status:
0.2 V
0 A
15.9 kW
Ready
0.2 V
2 A
15.9 kW
2 5
4 3
Status:
FGen [V]
FGen [A]
FGen [kW]
Ready
0.2 V
2 A
15.9 kW
Fig. 75 Main screen without (DISPLAY 1), left, and
with enabled and activated TFE option (DISPLAY 2), right
Main screen without/with enabled option TFE – DISPLAY 1, 2
1
2
3
4
5
Status line
The system state is displayed:
Ready: Device is ready for operation, the output is electrically isolated
and the power semiconductor is inhibited.
Running: Device is in operation, the output is providing power.
If a load is connected current flows.
Warning: Device is still in operation, warning limit is exceeded, an
error may be approaching, e.g. over-temperature.
Indication: warning in the message bar -2-.
Error: Device is not ready for operation, the output is electrically
isolated and the power semiconductor is inhibited.
Indication: error in the message bar -2-
Stop: Is generated by the TopControl application on an update to
the firmware for the TC.GSS power supply.
The control electronics are inhibited. The output is electrically
isolated and the power semiconductor is inhibited.
After the update the device must be switched off briefly via
the circuit breaker and then switched back on again.
Message bar
Short description in case of error messages and warnings.
E.g. “Communication” message if the interlock connector is not fitted.
Actual values
Indication of the actual output values: voltage U, current I and power P.
Set values
Indication of the reference values: voltage U, current I and power P.
TFE display
If the function generator option is enabled and activated, set value -4- changes
to “FGen”. The change in the indication to “FGen” appears as per the function
sequence set.
See DISPLAY 23, 31 function generator Fig. 82, Seite 147.
Table 55 Parameters on the main screen DISPLAY 1, 2
2011-10-18 140 / 298 V00.05b
7
1
2
3