Manual

Manual – TopCon TC.GSS
7.2. Analogue interface
Analogue interface
Activation of the analogue interface for remote control
Short description of the analogue interface
The operation of the analogue interface is defined by the pin definition
for the analogue interface X105.
Set values can be specified by applying a reference voltage to the inputs
for U, I, P, R on the analogue interface.
Pin definition of the analogue interface X105
For further information see 10.1.6.6, page 271.
Activation of the analogue interface for remote programming
For further information see chapter 7.2.1, page 120.
Utilisation of the Multi Rack Controller (MRC)
Operation of the master devices in several multi-unit systems to
form a large multi-unit system.
7.2.1. Activation of the analogue interface for remote control
The analogue interface can be activated via all the interfaces in the
device, and also via the analogue interface itself.
Activation of the analogue interface without HMI for remote control
The analogue interface is activated via itself.
Activation is via pin 20 on the digital input on the analogue interface by
means of the following signals:
Rising edge from 0 V to 24 V.
If the ANALAOG_REFERENCE_SELECT signal has already
reached the high level of 24 V on power-up.
For information on the pin definition see Table 147, page 271.
Pay attention to the interface hierarchy.
2011-10-18 120 / 298 V00.05b
7