Manual

Manual – TopCon TC.GSS
TopControl application
Tab –
Group – “Actual values Q4” – “Inverter”
Visible with “Source selector” selection:
“Master” or “Device” (single device).
Indication of actual parameters for the inverter.
Fig. 102 Group – “Actual values Q4” – “Inverter”
STATUS tab – “Actual values Q4” group – “Inverter”
1
2
3
4
Heatsink Temperature, read-only indication [°C]
Inverter heat sink temperature
DC Current , read-only indication [A]
Indication of the inverter DC current for the regeneration
Line Frequency, read-only indication [Hz]
Indication of the actual mains frequency present
Current
Iq Reactive current term (imaginary term) of the total current
Id Active current term (real term) of the total current
Three-phase AC current and voltage
Indication of the actual Q4 parameters as a table
Columns: Phase values at the transformer coils L1(U), L2 (V), L3 ( W)
Rows: Umax: Maximum AC voltage per phase
Imax: Maximum AC current per phase
Iavg: DC term per phase
PFactor: Power factor cosφ
(relationship between active power and apparent
power)
Table 87 Group – “Actual values Q4” – “Inverter”
2011-10-18 182 / 298 V00.05b
1
2
3
4
7