Manual

Manual – TopCon TC.GSS
TopControl application
Tab –
Conditions for AAP and user-defined curves
To be able to edit and create curves, certain conditions must be met.
2
1
2011-10-18 193 / 298 V00.05b
5
3
4
Fig. 110 Condition for opening the windows for editing user-defined and AAP
curves.
Conditions for user-defined and AAP curves
1
2
3
4
5
Used Function Blocks, group
“General enable” in “General Setup” group must be selected.
At least one selection from Voltage, Current or Power must be made.
If a selection is not made or “General enable” is cleared, none of controls in
the “Function Block” group box for editing are available.
Function Block, group
Depending on the “Used Function Blocks” -1- selected a corresponding
function block can be selected in the list box.
The selection made here defines the reference value for the Y axis in the
editor window -5-.
Base Function, group
One of the following entries must be selected in the list box
User defined: The label for -4- changes to “Edit user defined...”
AAP curve: The label for -4- changes to “Edit AAP...”
/, button
The button changes its label and its function to suit the selection in -3-.
A window for editing curves is always opened using the button.
Window
Depending on the selection in -2- and -3- the window for user-defined or
AAP curves opens.
Table 94 Conditions for user-defined and AAP curves.
7