Manual

Manual – TopCon TC.GSS
TopControl application
Menu – File
7.4.7. Using the software – menu bar
7.4.7.1. Menu – File
Items on the File menu
1
2
3
4
Fig. 91 Items on the File menu.
Connect…
TopControl attempts to establish a connection to an active TC.GSS power
supply via the COM interface.
Once a device has been found, communication is initialised.
For information on establishing a connection, see chapter 7.4.3.2,
Seite 161.
Disconnect
Closes the active connection.
If the TopCon is in the “Voltage On” status, the software outputs a warning
that must be accepted using Ok so that the connection can be closed.
Functions reserved for the manufacturer
Only for use by the manufacturer!
Parameters, user level required: “Advanced User”
Store to file... TopCon GSS power supply parameters are saved as
a gridfile.
Restore from File Parameters saved as a gridfile are written to the TC.GSS
power supply.
For further information see Table 77, Seite 168.
5 Exit
The TopControl application is quit.
2011-10-18 167 / 298 V00.05b
1
2
Table 76 Items on the “File” menu on the menu bar.
3
4
5
7