Manual

Manual – TopCon TC.GSS
“Select signal” window
TopControl application
Tab –
The parameters for the standard scope signals and the usage of gridfiles
are described using the tab, see chapter 7.4.8.8,
page 231.
5
Fig. 120 “Select signal” window from tab.
“Select signal” window – parameters
1
2
Signal source, options, list box
Standard scope signals: default.
2011-10-18 207 / 298 V00.05b
1
2
Gridfile: List with variable names/address allocations can be loaded
using the button and displayed for selection
in -2-.
Gridfiles are necessary for specific solutions and can be
requested from support if required.
See tab chapter 7.4.8.10, page 235
Varfile: Only for use by the manufacturer.
Signal list
Indication of the signals available that vary depending on the “Signal source” -
1-. Double-clicking a variable (line) selects this variable, closes this dialog box
and opens the main window again.
Alternatively: click once and press -3-
signal name: Name of the signal/variable
group Group name of the signals. Every signal is allocated to a
group that can be indicated as part of the specific group
using -4-.
type Variable type. Here 16-bit integer signed
address Address in the memory in the TC.GSS power supply
note Concise description of the signal variables
The table is continued on the next page.
4
3
7