Manual

Manual – TopCon TC.GSS
Installation and commissioning
Switching on and off a TopCon power supply
6.3. Switching on and off a TopCon power supply
6.3.1. Prior to switching on for the first time
Prior to switching on for the first time, the following points are to be
checked:
Does the information on the type plate match the mains connection
and load?
Mains connection correctly wired?
Adequate cable cross-section used?
For further information see chapter 6.2.3.2, page 112.
Loads connected with correct polarity?
For further information see chapter 6.2.3.3, page 113.
Control signals connected correctly?
For information on X101/X102 see chapter 4.3.2, page 46.
For information on X105 see chapter7.2, page 120.
Interlock inhibit wired?
For further information see 4.3.3, page 48.
Preparing interlock and communication bus correctly
Connect the control interface (X105) to the 25-pin dummy plug
(device rear side)
The CAN bus for the device communication is connected.
Situation: no RCU (Remote Control Unit) available.
The communication and interlock interface (X101) on the rear
side of the TopCon power supply is terminated using the “Interlock
and CAN-Term” dummy plug (9-pin) (device rear side).
Situation: RCU (Remote Control Unit) available.
Connect the connection cable to the communication and interlock
interface (X101) on the rear side of the TopCon power supply.
The other end is connected to the RCU interface (X101).
The “Interlock and CAN-Term” dummy plug is connected to
connector X102 on the RCU. (Device rear side)
2011-10-18 114 / 298 V00.05b
6