Manual

Manual – TopCon TC.GSS
6.2. Commissioning
6.2.1. General
Installation and commissioning
Commissioning
TopCon TC.GSS power supplies are prepared so that they can be
installed, wired and interference suppressed in accordance with the
applicable regulations with as little effort as possible. Nevertheless, the
responsibility for the compliance of systems and machines with built-in
TopCon TC.GSS power supplies remains with the manufacturer of the
system or machine.
On the usage of the electrical power supply in certain application areas,
the related applicable standards and health and safety regulations are
to be followed.
6.2.2. Safety information
WARNING
Possible mortal danger due to electric shock!
Avoidance:
Never connect or disconnect electrical connections while they
are live.
Do not open the device if it is in operation, as it contains live
parts.
Lay cables carrying high currents using an adequate cable
cross-section.
Wait min. 15 minutes!
In the devices built-in there can be dangerous voltages after
switching off the mains voltage, as well as in case of
loads that store energy.
Only use the devices for the intended application and type of
load.
In particular, the mains voltage and load must match the information
on the type plate, as well as the settings on the device.
Protection against touching the output current bars!
E.g. by fitting a suitable case.
2011-10-18 109 / 298 V00.05b
6