Manual

Manual – TopCon TC.GSS
Analogue interface
Activation of the analogue interface for remote control
Activation of the analogue interface with HMI (option)
for remote control
Using the “analogue” selection in the HMI, the control over the system
can be transferred to the analogue interface.
If this setting is to be retained on the next system start, to save the
settings the RS-232 interface and the TopControl application must
be used.
The HMI interface does not have any feature for saving settings.
Activation of the analogue interface via RS-232 using the
TopControl application for remote control
3
Fig. 60 Activation of the analogue interface via the
list box.
The remote control is transferred to the analogue interface as follows:
2011-10-18 121 / 298 V00.05b
1
On the -1- tab, select in the -2- list box the “Analog inputs” -3- entry.
If the analogue interface is to be activated the next time the
TC.GSS power supply is powered up, you must save the
selection using the -4- button.
2
7
4