Manual

Manual – TopCon TC.GSS
Multi-unit system
Internal system communication
4.4.3.6. Multi-unit system and TopControl application
Only the master is configured in the multi-unit system using the Top-
Control application.
Necessary conditions for configuration:
The master device in the multi-unit system must be connected to
a PC on which the TopControl application is running.
CAN connection to all devices in the multi-unit system see chapter
4.4.3.3, Seite 61.
Procedure for the multi-unit system configuration using
TopControl
Fig. 38 Setting up multi-unit system using TopControl
On the -1- tab press the
-2- button.
The “Multi module system configuration” -3- window opens.
Set the parameters for the multi-unit system.
For further information on the meaning and entry of the parameters
see Table 115, Seite 224.
Accept your entries using the -4- button.
A message appears with the rest of the procedure.
Set up the addresses of all the devices in the multi-unit system,
as per chapter 4.4.3.3, Seite 62.
Restart all devices to complete the multi-unit system configuration.
During this process switch back on all devices within 10 s. The
master device last.
2011-10-18 68 / 298 V00.05b
1
2
4
3
4