Manual

Manual – TopCon TC.GSS
TopControl application
Tab –
5
1
4
Overview of tab.
tab – parameter overview
5
6
7
8
9
Digital outputs:
2011-10-18 245 / 298 V00.05b
2
6 7 8 9
Warn Relais Pin WARN_a/b/c on X105 is set high.
OK/Alarm Relais Pin OK/ALARM_a/b on X105 is set high.
Run Relais Pin RUN_a/b on X105 is set high.
Pump On/Off Switch on the water pump for the internal cooling.
External (front) LEDs: are switched on
Power LED “POWER”; Status LED ”STATUS”;
Error LED “ERROR”; CV LED “ VOLTAGE”;
CC LED “CURRENT”; CP LED “POWER”
Internal LED: Life LED is switched on
Only for use by the manufacturer!
LED on the controller board.
Debug Out 1-4 Only for use by the manufacturer!
Q4 Enable out Pin Q4 Enable on X101/X102 is set high.
Break on For the discharge device option, pin is set high to activate
the discharge device.
CTR to IBC 1..3 Only for use by the manufacturer!
App Dig Out1 The App Dig In1 pin on the X105 interface is defined as an
output on activation. The pin is set low.
Aux on Only for use by the manufacturer!
Aux out Only for use by the manufacturer!
Table 125 Parameters on the tab – some parameters relate to interface X105. For the
pin definition of X105 see chapter 10.1.6.6, page 271.
3
7