Manual

Manual – TopCon TC.GSS
Operating modes
Setting operating states
4.2.2.2. Setting set values via HMI
For further information on the operation of the HMI see chapter 7.3,
page 131.
The specification of the parameters using the HMI is only fully suitable
for Q1 operation.
For Q4 operation it only possible to specify set values for the current,
voltage and power, but not for the limit values.
1
3
5
Output settings
Voltage
Current
Power limit
internal resistance
*Quit menu*
Fig. 16 Output settings display - HMI window
Procedure for Q1/Q4 operation
Set the required voltage -1-.
Output settings
Voltage
Current
Power limit
internal resistance
*Quit menu*
Set the required set values for current and power -2-.
“+” sign = Q1 operation; “-” sign = Q4 operation
For Q1 operation set the corresponding limit values
for the power -3-.
Start the flow of energy from the AC side to the DC side using
the switch on the HMI panel.
4.2.2.3. Setting set values via the analogue interface X105
For further information on the operation of the device via the analogue interface
X105 see chapter 7.2 , page 120.
2011-10-18 39 / 298 V00.05b
2
4
4