Manual

Manual – TopCon TC.GSS
Group error: C) Login (continued)
Flashing
code
TopControl/HMI
indication
13-7 C6) TCLIN
missing
13-8 C7) Master did
not receive all
RFL subframes
from HMI/RCU
13-9 C8) CAN protocol
version is not
identical
13-10 C9) Software
version is not
identical
13-11 CA) Slave CAN
protocol version
is not identical
13-12 CB) HMI/RCU
CAN protocol
version is not
identical
-- 2)
CC) HMI/RCU
did not receive
CFL
Description
Appendix
Error list
The TopCon master is
not finding a TCLIN on
system start
The same CAN protocol
or the same software
is not installed
on all devices
The HMI/RCU version
does not match the
actual firmware
The HMI/RCU has not
received a request to
log into the system
Possible reason
Measure to rectify
10
The TopCon master cannot establish the connection.
Restart: switch on TC.LIN before TC.P
Check CAN cable
The software versions on devices involved must be
identical to the versions on the master device
Contact the manufacturer to obtain compatible versions
A master has not been defined
Ensure that a TopCon master (module ID=0) is
available
There is no voltage at the controller board for the master
(LEDs remain off on switching on)
On repeated occurrence contact the manufacturer
Master device was switched on before the HMI/RCU
was switched on
Always switch on master at the same time or after
all HMI/RCU (maintain 10-second timeout)
Master device was not switched on after the end of the
10s HMI/RCU timeout
Also switch on master within 10s of switching on the
HMI/RCU
Master slave cable or RCU cable not connected
Check cabling
TC.GSS power supplies in generation 3 will only run
with HMI firmware V1.xx.yy. TopCon power supplies in
generation 4 (TopCon Quadro) will only run with HMI
firmware V4.xx.yy or V11.xx.yy
Only operate compatible devices in a multi-unit system.
Subsequent error for a CAN bus error
See above, error 60/61)
2011-10-18 290 / 298 V00.05b