Manual

Manual – TopCon TC.GSS
Appendix
Error list
10.2.2.13. Error group C) Login
Group error: C) Login
Flashing
code
TopControl/HMI
indication
13-1 C0) Slave did not
receive CFL 1)
13-2 C1) Slave received
invalid
CFL 1)
13-3 C2) Slave did not
receive EOL
13-4 C3) Slave receivedincomplete
EOL
Description
The slave has not
received a request to
log into the system
Invalid login attempt
Possible reason
Measure to rectify
A master has not been defined
Ensure that a master (module ID=0) is available
Master device was switched on before the slave was
switched on
10
Always switch on master at the same time or after
all slaves (maintain 10-seconf timeout)
Master device was not switched off after the end of the
10s slave timeout
Also switch on master within 10s of switching on the
slaves
Master-slave cable not connected
Check cabling
There is no voltage at the controller board for the master
(LEDs remain off on switching on)
On repeated occurrence contact the manufacturer
TC.GSS power supplies in generation 3 and 4
(TopCon Quadro) are not CAN-compatible
Only use devices in the same generation in a
multi-unit system
Subsequent error for a CAN bus error
See above, error 60/61)
Subsequent error for error C0)
See above, error C0)
Communication error
See above, error 60/61)
1) These errors cannot be detected by the master. They only occur on the slave.
13-5 C4) TCLIN CAN
protocol version
is not identical
13-6
C5) Master did
not receive all
RFL subframes
from slaves
Master and TCLIN
cannot communicate
Missing CAN initialisation
packets detected
TCLIN has a different CAN version to the master
Firmware update on TC.LIN or TC.P master
Communication error during the initialisation phase
See above, error 60/61)
2011-10-18 289 / 298 V00.05b