Manual

Manual – TopCon TC.GSS
Appendix
Error list
10.2.2.16. Error group F) Miscellaneous
Group error: F) Miscellaneous
Flashing
code
TopControl/HMI
indication
16-1 F0) Voltage
sensing not
allowed in
series configuration
16-2 F1) Wrong op-
Description
Possible reason
Measure to rectify
It is not allowed to activate the sense functionality on operation in series
Only use sense functionality in single operation or in a parallel
multi-unit system
tion code
An invalid option code has been entered
Enter option code again correctly, if necessary contact the manufacturer
16-3 F2) Interlock As soon as the interlock Interlock circuit has not been wired
circuit is disconnected, (for correct wiring see operating instructions)
the power stage shuts Fit suitable connectors to interface X105 and
down.
X101/X102
Connect interlock circuit differently, e.g. using
relay contacts
16-4 F3) External
PWM shutdown
Shutdown of the power
stage caused by an external
signal
10
Interlock circuit has been opened by external protection
circuit
Check why the protection circuit has tripped
The signal is normally not wired to the output. I.e.
only very heavy EMI could cause this error
Locate source of EMI, e.g. contactors without
free-wheeling diodes
On repeated occurrence contact the
manufacturer
Customer-specific error
16-5 F4) Security
relais open
16-11 FA) Any Rack
system did
not change
to voltage-on
or –off within
specified
timeout
16-12 FB) Any Rack
system has
errors, or
dummy plug
missing
Customer-specific error
16-13 FC) ReGen error Error in an optional ex- See separate documentation on the overall
ternal regeneration unit system
16-14 FD) AC-Switch Error in the external See software documentation V11.09.00
error polarity reverse bridge
(simple variant with contactors)
16-15 FE) AC-Bridge Error in external
See operating instructions for the bipolar
error TopCon bipolar switch
(TopCon option)
switch
16-16 FF) FIFO queue Buffer for actual value Subsequent error for a CAN communication error
for actual synchronisation in multi- [Group error 6) ]
values full unit operation is full See group error 6)
2011-10-18 294 / 298 V00.05b