Manual

Manual – TopCon TC.GSS
TopControl application
Tab –
“General setup” group on the tab
1
2 4
3 2
Fig. 104 “General setup” group on the tab - overview.
tab – “General setup” group
1
2
3
4
“General enable”, check box
Selected: The function generator is switched on.
Parameters can be entered.
Cleared The function generator is switched off
Entire register is not available.
No parameters can be entered.
“Used Function Blocks”, group of check boxes
The following reference values can be selected separately or in combination
to define one or more function blocks: “Voltage”, “Current”, “Power”
/, buttons
Saves or loads a function sequence from the file system on the computer.
For further information see Fig. 106, Seite 187.
/, buttons
Saves or loads a function sequence from the internal non-volatile memory
(flash) in the TC.GSS power supply.
For further information see Table 90, Seite 186.
Table 89 Parameters in the “General setup” group - overview.
2011-10-18 184 / 298 V00.05b
7