Manual

Manual – TopCon TC.GSS
7.4.8.6. Tab –
CAUTION
TopControl application
Tab –
User level: from Advanced User
On the tab all limit values can be set to protect a load
connected, and also the internal modules from overload.
Example I 2 t parameter
The integral of the load limit from the semiconductors defines the maximum
current allowed in a semiconductor that is allowed to flow through
the semiconductor in a limited time before the semiconductor is damaged.
A limit value for a load can be derived from this parameter. The square
of the current is included in the calculation.
Calculation example for the Error Limit
ILoadNom : Nominal current for the load e.g. 100 A
ILoadMax : Maximum overload current: 150 A for 5 s
Damage to the load possible!
Modified parameters can change the various safety limits for the
TC.GSS power supply to such an extent that the following damage may
result:
Damage to a load connected.
Avoidance:
Before you change parameters, make sure that these changes
are really necessary.
Contact support before you make changes to parameters.
Check your parameter changes for mistakes before you save
them to the TC.GSS power supply.
2011-10-18 226 / 298 V00.05b
7