Manual

Manual – TopCon TC.GSS
6.3.2.4. Function test
Condition for the function test:
Installation and commissioning
Switching on and off a TopCon power supply
Mains voltage switched on.
Connected load.
Vary the procedure depending on which interface you use.
With analogue interface X105
The control signal VOLTAGE_ON can be applied from a
possible input device (e.g. PLC, 12 VDC power supply) via
the interface X105. Set values can also be defined via this
interface.
For further information see chapter 7.2.3, Seite 122.
With the HMI (option)
Set values can be defined via a rotary switch on the related
menu.
Further information from chapter 7.3.4, Seite 134.
With the RS-232 interface
In combination with a PC and the TopControl application the
set values can be defined on the tab and the
device switched on.
For further information see chapter 7.4.8.1,page 175
Check the output voltage or current to ensure it matches the set values.
Please note that, depending on the configuration of ramp functions, the
set values specified may in some circumstances only be reached after
the related ramp functions/time have been completed.
2011-10-18 117 / 298 V00.05b
6