Manual

Manual – TopCon TC.GSS
Sense configuration
Single device operation – special aspects
Sense connection
+
X104 S+
S -
1
-
-
2011-10-18 44 / 298 V00.05b
+
X104 S+
S -
Fig. 21 Connection of load with sense function, not switched -1- or
switched -2-.
The sense cables are connected directly across the load. Here it is allowed
to install a switch (contactor) -2- in the load circuit. The maximum
output voltage Uout can be configured via the software. The output voltage
can be limited via the value configured. For further information on
the significance of the parameters see chapter 7.4.8.1 ,page 175.
Output of the sense voltage via the analogue interface X105
With the sense function activated, the analogue sense voltage actual
value can be used for the indication via the analogue interface X105.
For further information on the pin definition of X105 see chapter
10.1.6.6, page 271.
-
-
2
K1
4