Manual

Manual – TopCon TC.GSS
TopControl application
Tab –
In the TopControl application the analogue input signals on interface
X105 are allocated the following numerical values as set values that are
displayed on the tab:
Input/output signal -10 V ≙ -4000 numerical value
Input/output signal 0 V ≙ 0 numerical value
Input/output signal 10 V ≙ 4000 numerical value
In the case of recalibration, please contact Regatron support.
1
Fig. 131 Overview of tab.
tab – parameter overview
1
2
3
4
Analog reference inputs, group
Adjustment of the analogue inputs on interface X105 for voltage, current,
power and internal resistance. The maximum and minimum signal level on the
analogue input X105 is calibrated using the gain and the offset.
The indication on the right shows the numerical value actually measured.
Measurements, group
Adjustment of the indication for the voltage and current measured value acquisition
indication via the arrow buttons.
The related actual normalised value is indicated on the right.
Analog outputs, group
Adjustment of the analogue outputs on interface X105 for voltage and current.
The maximum and minimum signal level on the analogue output X105 is calibrated
using the gain and the offset.
The “Manual D/A control” check box switches on the manual calibration. I.e.
the “Voltage” and “Current” values are output on the analogue outputs.
Store settings, button
Settings made on the tab are permanently saved. The actual
parameter set is saved from the RAM to the flash PROM in the TC.GSS power
supply.
Table 118 Overview of the tab.
2011-10-18 229 / 298 V00.05b
4
2
3
7