Manual

Manual – TopCon TC.GSS
Appendix
Error list
10.2.2.1. Error group 0) Internal
Group error: 0) Internal
Flas
hing
code
TopControl/
HMI
indication
1-1 00) Invalid systemstate
1-2 01) Invalid
module state
1-3 02) Calculation
Overflow
1-5 04) EEPROM
table write
1-6 05) Flash timeout
1-7 06) ADC
sequence
1-8 07) Invalid EE-
PROM table
1-9 08) Requested
state not available
1-10 09) Thyristor not
switched on
1-11 0A) No active
controller defined
1-12 0B) ADC timeout
1-13 0C) ADC DMA
interrupt missing
1-15 0E) Invalid interrupt
routine
called
1-16 0F) Old
EEPROM table
loaded
Description
Invalid state has been
detected.
For debug purposes
Overflow in internal calculation
trapped
Error on writing the device
parameters to the nonvolatile
memory
Timeout occurred on writing/deleting
a flash sector
AD-converter sequence in
wrong order
Device parameter table
empty or invalid
Unexpected state transition
detected. For debug
purposes
Thyristor for bypassing
the intermediate circuit
charge resistor is not
switched on (nominal
condition).
For debug purposes
An active controller has
not been defined. For
debug purposes
Timeout occurred during
actual value acquisition
Actual value acquisition
incomplete
Unexpected interrupt routine
has been called. For
debug purposes
Version in device parameter
table does not match
actual software
Possible reason
Measure to rectify
On repeated occurrence contact the
manufacturer
10
Wrong parameter set
After a software update ensure that all parameters
supplied have been loaded and saved
Update from V4.11.33 or earlier to V4.11.34 or later
After power up "Store settings" and restart
device.
On repeated occurrence contact the
manufacturer
Heavy EMI pulse affecting AD data stream
Earth devices using large area connections
Locate source of EMI, e.g. contactors without
free-wheeling diodes
On repeated occurrence contact the manufacturer
Subsequent error for error 06
See above, error 06
On repeated occurrence contact the manufacturer
Occurs after a firmware update on the MainDSP
After a software update ensure that all parameters
supplied have been loaded and saved. See also
software update instructions
2011-10-18 278 / 298 V00.05b