Manual

Manual – TopCon TC.GSS
Manual triggering
TopControl application
Tab –
Conditions for manual triggering are:
(i.e. the button can be clicked)
In the “Trigger mode” list box the entry “Manual” has been
selected.
The TC.GSS power supply is in the “VOLTAGE_ON” state, see
tab.
Fig. 108 Options during manual triggering.
tab – “Trigger mode” group
1
2
3
4
1 2
, button is clicked
Trigger event triggers the function sequence.
Button changes the function to -2-
-3- button is activated.
If in Table 91, Seite 188 a specific number of function runs has been
defined, the button changes automatically to -2-.
, button is clicked
Function sequence is ended and the TC.GSS power supply adopts the
output value set in Table 91, Seite 188.
Function sequence can be started again via -1-.
button is clicked
The function sequence is paused.
The actual output value is retained.
Button changes the function to -4-.
button is clicked
The function sequence is continued.
Button changes the function to -3-.
Table 92 Manual triggering.
2011-10-18 189 / 298 V00.05b
3
4
7