Manual

Manual – TopCon TC.GSS
TopControl application
Tab –
Group – “Common actual values”
This group is always visible independent of the selection in “Source selector”.
1
2
3
4
5
Fig. 99 “Common actual values” group on .
STATUS tab – “Common actual values” group
1
2
3
4
5
Actual state, read-only indication
Indicates the actual system status of the master device or slave device, depending
on the selection in “Source selector” 1 .
For further information on system states see Table 20, Seite 51
Output voltage/current/power, read-only indications
The actual values for the output voltage, output current and output power are
displayed. The actual values are dependent on the selection in
“Source selector” 1 .
Sense voltage/power, read-only indication
The sense power indicated is calculated from the sense voltage measured
and the actual current.
(Actual current value is dependent on “Source selector” 1 ).
System output voltage/current/power, read-only indication
The system parameters indicated (system output voltage, output voltage and
output power) are determined from the type of configuration in the multi-unit
system.
For further information on multi-unit operation see Table 115, page 224.
Primary current , read-only indication
Indication of the device internal primary current (DC intermediate circuit to the
output transformer). The indication is dependent on the selection in “Source
selector” 1 .
Table 84 “Common actual values” group.
1 Depending on “Source selector”
2011-10-18 179 / 298 V00.05b
7