Manual

Manual – TopCon TC.GSS
TopControl application
Tab –
Parameter list – meaning of the columns (continued)
6
7
8
value, read-only indication
Variable value. The indication is dependent on the type -4-. The following
value indications are possible, see check boxes Table 123, Seite 240:
Numerical value Value range is dependent on the variable selected.
Physical Indication of the physical value with unit, if the value has a
“Physical ref” allocation -8-.
Verifying Numerical value or physical value is indicated with the values
saved in the TopCon for verification.
The values saved in the TopCon are indicated in brackets.
Indication only if “verify” has been run and “show verify” is
selected, see Table 123, Seite 240.
note
Comment field with useful information on the content of the variables.
Up to 60 alphanumeric characters.
physical ref.
Information on the reference values, e.g. whether they are system values or
module (device) values etc.
Correct allocation makes it possible to indicate the variable value as a physical
value, e.g. in [V] for Volt, instead of normalised.
Table 122 Meaning of the columns in the parameter list.
2011-10-18 238 / 298 V00.05b
7