Manual

Manual – TopCon TC.GSS
Error-free state
Installation and commissioning
Switching on and off a TopCon power supply
After you have set the set values, the following occurs in the error-free state:
The output is switched on and regulated to the related set value
defined.
The device is in the state: RUNNING,
One CONTROL LED illuminates depending on the controller that
is providing the limiting.
CV for voltage controller
CC for current controller
CP for power controller
Error state
In the error state a flashing error code is output on the front via the
CONTROL LED.
For further information see chapter 10.2, from Seite 275.
If there is no output voltage at the device, check the interlock circuit using the
related dummy plugs.
For further information see chapter 4.3.3, Seite 48.
2011-10-18 118 / 298 V00.05b
6