Manual

Manual – TopCon TC.GSS
Appendix
Error list
10.2.2.2. Error group 1) Internal (PDSP)
Group error: 1) Internal (PDSP)
Flas
hing
code
TopControl/
HMI
indication
2-1 10) PDSP packagechecksum
2-2 11) Wrong
PDSP SW version
Description
System communication
malfunction
Peripheral DSP version
does not match the
MainDSP version
2-3 12) PDSP fault Internal has occurred.
2-4 13) Write queue
overrun
2-5 14) Too many
PDSP packages
2-6 15) SCI checksum
2-7 16) SCI parity
2-8 17) SCI overrun
2-9 18) SCI framing
2-10 19) SCI break
Possible reason
Measure to rectify
Heavy EMI pulse
Earth devices using large area connections
Locate source of EMI,
e.g. contactors without free-wheeling diodes
10
- During a software update the peripheral DSP has not
yet been updated to the latest state
- Latest parameters not loaded after software update
Undertake software update exactly as stated in the
instructions
On repeated occurrence contact the manufacturer
Various RS232 errors - Interference on RS232 cable
Earth devices using large area connections
Possibly use shorter cable
Possibly use shielded cable
Avoid earth loops, electrically isolate RS232
Locate source of EMI,
e.g. contactors without free-wheeling diodes
- Wrong RS232 timing set (baud rate, stop bit, parity bit,
...)
For correct values see operating instructions
- Level switching on RS232 after switching on or off a
PC/laptop
(Error 18) )
Connect RS232 cable only after starting the
PC/laptop or disconnect prior to switch off
Update the peripheral DSP to V0.11
- Incorrect inactive RS232 level on host side as long as
interface is not opened
(Error 18) )
Update the peripheral DSP to V0.11
Start TopControl and leave to run to open the
interface. The error cannot be acknowledged
2011-10-18 279 / 298 V00.05b