Manual

Manual – TopCon TC.GSS
Operation of the HMI (option)/RCU (option)
VLS settings (page 1) – DISPLAY 24
VLS settings (page 1) – DISPLAY 24
Fig. 84 VLS settings page 1 – DISPLAY 24
VLS settings page 1 – DISPLAY 24
1
2
3
4
5
1
3
5
VLS settings page 1
Input
Function
Action
Output
VLS disabled
upper limit
close relais
warn relais
VLS page 2 ...
Input, menu item
Selection of the actual values to which the VLS function reacts:
VLS disabled: The VLS function is disabled.
DISPLAY 5 and DISPLAY 6 cannot be seen on the DIS-
PLAY.
Voltage: VLS reacts to the actual value for the output voltage.
Current: VLS reacts to the actual value for the output current.
Power: VLS reacts to the actual value for the output power.
Function, menu item
Selection of the thresholds from -1- at which the VLS function reacts:
upper limit: VLS reacts to an upper signal threshold.
lower limit: VLS reacts to a lower signal threshold.
inside window: VLS reacts to signals within threshold window.
outside window: VLS reacts to signals that are outside a threshold window.
Action, menu item
How the switching relay defined in -4- is to react:
open relais: The relay is to open when the state set in -2- occurs.
close relais: The relay is to close when the state set in -2- occurs.
Output, menu item
Which relay is to be operated with VLS.
warn relais, run relais, OK/alarm relais.
VLS page 2 ... , navigation item
Continue to page 2 of the VLS settings – DISPLAY32
Table 64 VLS settings page 1 – DISPLAY 24
2011-10-18 151 / 298 V00.05b
2
4
7
VLS settings page 1
Input
Function
Action
Output
VLS disabled
upper limit
close relais
warn relais
VLS page 2 ...