Manual

Manual – TopCon TC.GSS
TopControl application
Tab –
Group – “Actual values Q1”
Visible with “Source selector” selection:
“Master” or “Device” (single device).
Fig. 100 “Common actual values” group on .
STATUS tab – “Actual values Q1” group
1
2
3
Temperature [°C], read-only indications
Temperature IGBT Indicates the IGBT temperature on the heat sink
Temperature Rectifier Indicates the rectifier temperature on the heat sink.
DC link voltage [V], read-only indication
Indication of the intermediate circuit voltage.
Supply voltage [V]
Indication of the supply voltage for the controller board.
Comparison of set values and actual values.
If there are large differences between the values, an error message is output.
Table 85 “Actual values Q1” group.
2011-10-18 180 / 298 V00.05b
1
2
3
7