Manual

Manual – TopCon TC.GSS
TopControl application
Tab –
Multi-module system configuration dialog box
The following conditions must be met for multi-unit system operation:
Entries are made on the master device in the multi-unit system.
The master-slave principle on all devices involved in the multiunit
system see chapter 4.4.3.3, page 61.
2011-10-18 224 / 298 V00.05b
1
Fig. 128 The “Multi-module system configuration” dialog box is opened via
the -1- tab by clicking the -
2- button.
Multi-module system configuration - parameters
3
4
5
, list box
Single Device Device on its own.
Hidden: -4-, -5-
Multi-Load Although devices are remotely controlled from the master
device and they are connected via CAN, their power outputs
are not connected together.
Each slave device has its own load. Identical set values are
specified for each device.
Visible -4-
Matrix See Table 116, Seite 225.
1 , numeric box
Number of device in a multi-unit system that are connected in series.
1 , numeric box
Number of device in a multi-unit system that are connected in parallel.
6 2 , check box for TC.LIN
7 2 , list box for TC.LIN
Table 115 Parameters in the “Multi-module configuration” dialog box on the tab.
1 See Table 116, page 225 for examples.
2 Visible, if the TC.LIN option is fitted.
3
4
2
5
8
7
6
7
9