Manual

Manual – TopCon TC.GSS
7.3.5.3. Error during operation
Troubleshooting using the HMI
Warning group and Error group – DISPLAY 26/27
The errors that occur during operation are indicated both in the message
bar on the main screen and on the Error group menu – DISPLAY.
A differentiation is to be made between descriptions for group errors
and detail errors. Detail errors are combined into a group error. Only the
group error appears in the message bar, the detail errors can be
checked on the menu.
For a complete list of all group and detail errors, as well as the warnings,
see chapter 10.2, Seite 275.
The communication errors listed in the following table are initially displayed
in a separate window. After the selection knob or is
pressed, the separate window disappears and the message Communication
Error appears in the message bar on the main menu. The electrical
power supply changes to the Error operating state.
Error Reason and correction
CAN controller error The CAN controller is in the Bus-Off state.
No data received by HMI The HMI or RCU is not receiving any data.
Check the connection of the connection cable
between power supply and RCU
CANTERM terminating resistor present on the
end of the CAN bus?
Table 69 Error description for HMI errors during operation
In the TopControl application error lists can be further broken down.
The error list can also be cleared using the TopControl command “Clear
Errors”.
7.3.5.4. Warnings during operation
The warnings that occur during operation are indicated both in the message
bar on the main screen and on the Warning group menu. A differentiation
is to be made between descriptions for group warnings and
detail warnings. Detail warnings are combined into a group warning.
Only the group warning appears in the message bar, the detail warnings
can be checked on the menu.
For a complete list of all group and detail errors, as well as the warnings,
see chapter 10.2, Seite 275.
2011-10-18 156 / 298 V00.05b
7