Manual

Manual – TopCon TC.GSS
TopControl application
Tab –
tab – parameter overview
1
2
2
3
4
Digital inputs, group with status read-only indications
Depending on the status Green ≙ Active
Grey ≙ Inactive
Interlock Pin name on the interface: INTERLOCK_IN_+
Digital input 1-4 Pin name on the interface: APP_DIGITALIN_1-4
Debug In 1-4 Only for use by the manufacturer!
Flash Ready Only for use by the manufacturer!
Voltage on Pin name on the interface: VOLTAGE_ON
Tests, group with check boxes
Disable DC link test
Disable the intermediate circuit voltage monitoring.
Disable output current underrange test
Disable the negative output current monitoring.
Disable output current overrange test
Disable the AD measuring range limit monitoring for the
output current.
External (front) LED:
Power LED “POWER”; Status LED “STATUS”;
Error LED “ERROR”; CV LED “ VOLTAGE”;
CC LED “CURRENT”; CP LED “POWER”
Internal LED: Life LED; Exception LED
Only for use by the manufacturer!
LEDs on the controller board.
Digital outputs:
Warn Relais Pin name on the interface: WARN_a/b/c
OK/Alarm Relais Pin name on the interface: OK/ALARM_a/b
Run Relais Pin name on the interface: RUN_a/b
Debug Out 0-2 Only for use by the manufacturer!
Internal test points on the controller board.
Fan speed, group
Manual fan control
If selected, the speed of the fan can be controlled manually
using the slide.
Digital outputs, group with check boxes
Manual output control is selected (manual operation):
The LEDs no longer indicate the device status.
Digital outputs are no longer operated.
The LEDs on the front panel are turned on using check boxes.
The internal LEDs on the controller board are turned on using check boxes.
The digital outputs are operated using check boxes.
Manual output control in cleared:
All check boxes -5- to -9- can be selected.
The table is continued on the next page.
2011-10-18 244 / 298 V00.05b
7