Manual

Manual – TopCon TC.GSS
Installation of the software
Procedure on establishing communication
7.4.3.2. Start/communication with the TopCon power supply
Procedure on establishing communication
Switch on the power supply.
Start the TopControl application.
The software searches for the COM ports from port 0..10.
A connection is made automatically to the first TopCon power
supply connected via the serial interface.
If the TopCon power supply is not detected by the TopControl
application, the following message window appears.
Fig. 88 Message window if TopControl does not detect the TC.GSS power
supply.
The software is run in the Offline mode as soon as you accept
the message using the button.
Check the RS-232 connections!
Is the interface perhaps in use by another program or another instance
of TopControl?
If the virtual COM port > 10, you can connect a power supply to
the TopControl application using the following console command:
„C:\Program Files\Regatron\TopControl\TopControl.exe
/COMStart=5 /COMEnd=5'
Where COMStart= start of search and COMEnd= end of search
If the connection problem persists, please contact Regatron support.
If the communication between the TopControl application and the Top-
Con power supply fails, the connection can be re-established manually.
2011-10-18 161 / 298 V00.05b
7