Manual

Manual – TopCon TC.GSS
Scope display group
TopControl application
Tab –
The scope display depends on the following factors:
Number of channels selected.
Resolution/scaling in X and Y axis.
Zoom factor set.
2011-10-18 201 / 298 V00.05b
7
1 2 3
Fig. 115 Scope display group on the tab.
Scope display group – parameters
1
2
3
4
List box
This list box contains the list of the scope configurations available and makes
it possible to quickly change between different recording configurations. Default
configuration: “Scope configuration001.cfg”
, button is only active if the zoom function is in use.
If zoom in use:
Button is green.
Button is activated.
Button active If the button is clicked the display returns to the full indication
of the data.
The button is deactivated.
, button
Sets the zoom such that the curves shown are optimally indicated in both axis
ranges.
Display
Display with 4 curves and max. 4 comparison/reference curves.
Abscissa (X axis): represents the time axis.
Ordinate (Y axis): representation is dependent on the selected signal
variable. In the scope display many functions can be used
via the cursor (possibly with additional buttons). See
“Navigation in the scope display” Fig. 116, Seite 202.
Table 98 Parameters in the scope display group.
4