Manual

Manual – TopCon TC.GSS
CAUTION
TopControl application
Tab –
tab – parameters (continued)
4
5
I 2 t, with following text boxes
For explanation and example calculation see “Example I 2 t parameter ,
Seite 226
Current inom Nominal value for the load connected
Error limit Threshold that causes an overcurrent error.
Value range is device-dependent. (time value required)
Warn limit Threshold that causes an overcurrent warning.
Value range is device-dependent. (time value required)
Store settings, button
Settings made on the tab are permanently saved. The actual
parameter set is saved from the RAM to the flash PROM in the TC.GSS power
supply.
Table 117 Error and warning thresholds on the tab.
7.4.8.7. Tab –
User level: from Power User
Any adjustments to the measured value acquisition on the inputs and
outputs necessary during the test and setup phase for the TopCon GSS
power supply can be made using the parameters on the
tab.
For further information on analogue remote programming, see chapter
7.2.4, page 123Seite 123.
Damage possible due to decalibration!
Changes to the parameters can cause damage to the load connected:
The control circuit may overshoot, which will involve current
and voltage spikes that can irreparably damage the semiconductors.
Damage to a load connected due to excessively high
voltage, current or power steps.
Incorrect or imprecise display is possible.
Avoidance:
Before you change parameters, make sure a calibration is really
necessary.
Contact support before you make changes to parameters.
Check your procedure for the calibration again before you
save modified parameters on the TC.GSS power supply.
2011-10-18 228 / 298 V00.05b
7