Manual

Manual – TopCon TC.GSS
CAUTION
Options and system options
Hardware options
5.2.1.2. Characteristics of a water cooling circuit
General information on the heat exchanger
Parameter TC.P.20 TC.P.32
Connections On rear side of device, G 1/2“
Cooling medium (KM) 1
2011-10-18 73 / 298 V00.05b
5
Purified water, alternatively heat
exchanger liquids, non-corrosive
Heat sink material Corrosion-resistant steel
KM 1 specific heat capacity 4.2 kJ/kgK (water)
Thermal rating 1.5 kW 2.0 kW
Recommended flow rate KM 4 – 6 l/min
Minimum KM flow rate
for dT 10 K,
dT ≙ temp. difference between
inlet and outlet temp. of the cooling
liquid.
2.5 l/min
Table 31 Characteristics of the liquid cooling.
1 If you use cooling liquid with different parameter values contact Regatron support.
Damage due to condensation!
Damage in the device due to condensed water is excluded from the
warranty.
Reason:
Due to cooling liquid temperatures < 15 °C.
In case of an ambient temperature of 21 C and relative atmospheric
humidity of ≥ 70 %.
Avoidance:
Keep the feed temperature at a temperature level > 15 °C to
avoid condensation inside the device and on the supply cable.
In case of doubt contact Regatron support.