Manual

Recommendations

Info

<strong>Manual</strong> – TopCon TC.GSS Group error: C) Login (continued) Flashing code TopControl/HMI indication 13-7 C6) TCLIN missing 13-8 C7) Master did not receive all RFL subframes from HMI/RCU 13-9 C8) CAN protocol version is not identical 13-10 C9) Software version is not identical 13-11 CA) Slave CAN protocol version is not identical 13-12 CB) HMI/RCU CAN protocol version is not identical -- 2) CC) HMI/RCU did not receive CFL Description Appendix Error list The TopCon master is not finding a TCLIN on system start The same CAN protocol or the same software is not installed on all devices The HMI/RCU version does not match the actual firmware The HMI/RCU has not received a request to log into the system Possible reason Measure to rectify 10 The TopCon master cannot establish the connection. Restart: switch on TC.LIN before TC.P Check CAN cable The software versions on devices involved must be identical to the versions on the master device Contact the manufacturer to obtain compatible versions A master has not been defined Ensure that a TopCon master (module ID=0) is available There is no voltage at the controller board for the master (LEDs remain off on switching on) On repeated occurrence contact the manufacturer Master device was switched on before the HMI/RCU was switched on Always switch on master at the same time or after all HMI/RCU (maintain 10-second timeout) Master device was not switched on after the end of the 10s HMI/RCU timeout Also switch on master within 10s of switching on the HMI/RCU Master slave cable or RCU cable not connected Check cabling TC.GSS power supplies in generation 3 will only run with HMI firmware V1.xx.yy. TopCon power supplies in generation 4 (TopCon Quadro) will only run with HMI firmware V4.xx.yy or V11.xx.yy Only operate compatible devices in a multi-unit system. Subsequent error for a CAN bus error See above, error 60/61) 2011-10-18 290 / 298 V00.05b
<strong>Manual</strong> – TopCon TC.GSS Group error: C) Login (continued) Flashing code TopControl/HMI indication -- 2) CD) HMI/RCU received invalid CFL CE) HMI/RCU did not receive EOL CF) HMI/RCU received incomplete EOL Description Appendix Error list Possible reason Measure to rectify Invalid login attempt Subsequent error for error CC) See above, error CC) Communication error See above, error 60/61) Incorrect CAN protocol Only use compatible HMI and controller board software 2) These errors cannot be detected on the master device. For this reason there is also no flashing code and error can only be indicated on an HMI/RCU, but not in TopControl. 10 2011-10-18 291 / 298 V00.05b
Page 1 and 2:
TC.GSS Grid-tie Source Sink Regatro
Page 3 and 4:
Manual - TopCon TC.GSS Manufacturer
Page 5 and 6:
Manual - TopCon TC.GSS Using the ma
Page 7 and 8:
Manual - TopCon TC.GSS Table of con
Page 9 and 10:
Manual - TopCon TC.GSS General Tabl
Page 11 and 12:
Manual - TopCon TC.GSS 1. Product d
Page 13 and 14:
Manual - TopCon TC.GSS Mechanical d
Page 15 and 16:
Manual - TopCon TC.GSS 1.6. Positio
Page 17 and 18:
Manual - TopCon TC.GSS Position of
Page 19 and 20:
Manual - TopCon TC.GSS 2. Safety Ge
Page 21 and 22:
Manual - TopCon TC.GSS Categorisati
Page 23 and 24:
Page 25 and 26:
Manual - TopCon TC.GSS 2.2.5. Trans
Page 27 and 28:
Page 29 and 30:
Manual - TopCon TC.GSS Instructions
Page 31 and 32:
Manual - TopCon TC.GSS Controls and
Page 33 and 34:
Manual - TopCon TC.GSS 4.2. Operati
Page 35 and 36:
Manual - TopCon TC.GSS Operating mo
Page 37 and 38:
Page 39 and 40:
Page 41 and 42:
Manual - TopCon TC.GSS Single devic
Page 43 and 44:
Page 45 and 46:
Page 47 and 48:
Page 49 and 50:
Page 51 and 52:
Manual - TopCon TC.GSS Device state
Page 53 and 54:
Page 55 and 56:
Page 57 and 58:
Manual - TopCon TC.GSS Multi-unit s
Page 59 and 60:
Page 61 and 62:
Page 63 and 64:
Page 65 and 66:
Page 67 and 68:
Page 69 and 70:
Manual - TopCon TC.GSS 5. Options a
Page 71 and 72:
Manual - TopCon TC.GSS 5.2. Hardwar
Page 73 and 74:
Manual - TopCon TC.GSS CAUTION Opti
Page 75 and 76:
Manual - TopCon TC.GSS Options and
Page 77 and 78:
Page 79 and 80:
Page 81 and 82:
Manual - TopCon TC.GSS 5.3. Softwar
Page 83 and 84:
Page 85 and 86:
Manual - TopCon TC.GSS The gradient
Page 87 and 88:
Page 89 and 90:
Page 91 and 92:
Page 93 and 94:
Page 95 and 96:
Manual - TopCon TC.GSS 5.4.8. TC-Et
Page 97 and 98:
Page 99 and 100:
Page 101 and 102:
Page 103 and 104:
Page 105 and 106:
Manual - TopCon TC.GSS Installation
Page 107 and 108:
Manual - TopCon TC.GSS Cooling Inst
Page 109 and 110:
Manual - TopCon TC.GSS 6.2. Commiss
Page 111 and 112:
Page 113 and 114:
Page 115 and 116:
Page 117 and 118:
Manual - TopCon TC.GSS 6.3.2.4. Fun
Page 119 and 120:
Manual - TopCon TC.GSS 7. Device op
Page 121 and 122:
Manual - TopCon TC.GSS Analogue int
Page 123 and 124:
Page 125 and 126:
Page 127 and 128:
Page 129 and 130:
Page 131 and 132:
Manual - TopCon TC.GSS 7.3. HMI and
Page 133 and 134:
Page 135 and 136:
Manual - TopCon TC.GSS 7.3.4.2. HMI
Page 137 and 138:
Manual - TopCon TC.GSS HMI and RCU
Page 139 and 140:
Manual - TopCon TC.GSS Operation of
Page 141 and 142:
Manual - TopCon TC.GSS System scree
Page 143 and 144:
Manual - TopCon TC.GSS System setti
Page 145 and 146:
Manual - TopCon TC.GSS CAUTION Oper
Page 147 and 148:
Page 149 and 150:
Page 151 and 152:
Page 153 and 154:
Manual - TopCon TC.GSS Limit settin
Page 155 and 156:
Manual - TopCon TC.GSS 7.3.5. Troub
Page 157 and 158:
Manual - TopCon TC.GSS 7.4. TopCont
Page 159 and 160:
Manual - TopCon TC.GSS No CD-ROM dr
Page 161 and 162:
Page 163 and 164:
Manual - TopCon TC.GSS TopControl -
Page 165 and 166:
Manual - TopCon TC.GSS TopControl a
Page 167 and 168:
Page 169 and 170:
Manual - TopCon TC.GSS 7.4.7.2. Men
Page 171 and 172:
Manual - TopCon TC.GSS Setting the
Page 173 and 174:
Manual - TopCon TC.GSS 7.4.7.3. Men
Page 175 and 176:
Manual - TopCon TC.GSS 7.4.8.1. Tab
Page 177 and 178:
Page 179 and 180:
Page 181 and 182:
Page 183 and 184:
Page 185 and 186:
Page 187 and 188:
Page 189 and 190:
Manual - TopCon TC.GSS Manual trigg
Page 191 and 192:
Page 193 and 194:
Page 195 and 196:
Page 197 and 198:
Manual - TopCon TC.GSS Creating AAP
Page 199 and 200:
Page 201 and 202:
Manual - TopCon TC.GSS Scope displa
Page 203 and 204:
Manual - TopCon TC.GSS 4 TopControl
Page 205 and 206:
Manual - TopCon TC.GSS 8 7 6 TopCon
Page 207 and 208:
Manual - TopCon TC.GSS “Select si
Page 209 and 210:
Page 211 and 212:
Page 213 and 214:
Manual - TopCon TC.GSS Control grou
Page 215 and 216:
Page 217 and 218:
Page 219 and 220:
Page 221 and 222:
Page 223 and 224:
Page 225 and 226:
Page 227 and 228:
Page 229 and 230:
Page 231 and 232:
Manual - TopCon TC.GSS CAUTION 7.4.
Page 233 and 234:
Page 235 and 236:
Page 237 and 238:
Manual - TopCon TC.GSS Parameter li
Page 239 and 240: Manual - TopCon TC.GSS Filtering an
Page 241 and 242: Manual - TopCon TC.GSS Handling gri
Page 243 and 244: Manual - TopCon TC.GSS 7.4.8.11. Ta
Page 245 and 246: Manual - TopCon TC.GSS TopControl a
Page 247 and 248: Manual - TopCon TC.GSS 7.4.8.12. Ta
Page 249 and 250: Manual - TopCon TC.GSS 8. Maintenan
Page 251 and 252: Manual - TopCon TC.GSS CAUTION 8.2.
Page 253 and 254: Manual - TopCon TC.GSS System infor
Page 255 and 256: Manual - TopCon TC.GSS Device hardw
Page 257 and 258: Manual - TopCon TC.GSS Support Prod
Page 259 and 260: Manual - TopCon TC.GSS 9.6. Device
Page 261 and 262: Manual - TopCon TC.GSS Support Disp
Page 263 and 264: Manual - TopCon TC.GSS 10.1.2. Leak
Page 265 and 266: Manual - TopCon TC.GSS Times Starti
Page 267 and 268: Manual - TopCon TC.GSS Appendix Tec
Page 275 and 276: Manual - TopCon TC.GSS 10.2. Error
Page 277 and 278: Manual - TopCon TC.GSS Appendix Err
Page 289: Manual - TopCon TC.GSS Appendix Err
Page 295 and 296: Manual - TopCon TC.GSS TCP_Certific
Page 297 and 298: Manual - TopCon TC.GSS 11. Index an
show all

Manual

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?