Manual
Manual
Manual
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
<strong>Manual</strong> – TopCon TC.GSS<br />
TopControl application<br />
Tab – <br />
“Store/Load Function Sequence” window (continued)<br />
5<br />
6<br />
7<br />
8<br />
9<br />
10<br />
, button in the “Store Function Sequence” window<br />
Saves the actual function sequence in the sequence number -10- given<br />
(1...1000).<br />
The content of -8-, -9-, -10- is used for the save.<br />
If the sequence number exists:<br />
Confirmation prompt as to whether the existing “Function Sequence” is to<br />
be overwritten.<br />
, button in the “Load Function Sequence” window<br />
The button is activated by selecting a function sequence on the list -1-. (Selecting:<br />
click using the left mouse button)<br />
The selected function sequence is loaded from the non-volatile memory in<br />
the TopCon GSS power supply to the TopControl application.<br />
The “Load Function Sequence” window is closed at the end loading process.<br />
All parameters loaded are indicated on the tab and the<br />
curve shown in the preview.<br />
Cancel, button<br />
Closes the dialog box and has the following effect:<br />
Settings for remove autoload are retained.<br />
Settings for set for autoload are retained.<br />
Function sequences are not loaded.<br />
Function sequences are not saved.<br />
Function sequences deleted remain deleted!<br />
The changes made must be made known to the TC.GSS power supply.<br />
On the tab click the button, see Fig. 96,<br />
Seite 175.<br />
, button<br />
This button sets the actual date and time; values can also be modified<br />
manually in the “Date” and “Time” -8- boxes.<br />
Date/Time, text box<br />
Date and time entry can be edited manually or generated automatically via -7-.<br />
Name, text box<br />
<strong>Manual</strong> label entry for the function sequence.<br />
Label length: maximum 30 alphanumeric characters.<br />
Seq.Nr, text box<br />
Entry of the function sequence number.<br />
Entry: numeric; value range: 1 – 1000<br />
In case of duplicate numbers, a message appears on saving.<br />
Table 90 Parameters in the “Store Function Sequence” and<br />
“Load Function Sequence” window.<br />
Use e.g. the key data for a curve to label a function sequence. If there<br />
are several curves on the list -1- you will then be able to identify the<br />
characteristics of the curve from the label.<br />
2011-10-18 186 / 298 V00.05b<br />
7