Manual

Manual – TopCon TC.GSS
TopControl application
Tab –
Group – “Actual values Q4” – “Booster”
Visible with “Source selector” selection:
“Master” or “Device” (single device).
Indication of actual parameters for the booster.
Fig. 101 Group – “Actual values Q4” – “Booster”
STATUS tab – “Actual values Q4” group – “Booster”
1
2
3
4
Temperature
Heatsink Temp. Booster heat sink temperature.
PCB Temp. Temperature on the circuit board for the booster.
Voltages
DC link voltage Intermediate circuit voltage
Voltage Clamp Voltage at the charging capacitor for the booster.
Supply voltages
Indication of the supply voltage for the booster board.
Comparison of set values and actual values.
If there are large differences between the values, an error message is output.
Current
Current L Current in the storage choke for the booster.
Current Sek Current on the secondary side of the transformer.
Table 86 Group – “Actual values Q4” – “Booster”
2011-10-18 181 / 298 V00.05b
1
2
3
4
7