Manual

Recommendations

Info

<strong>Manual</strong> – TopCon TC.GSS Multi-unit system Internal system communication Note that the dummy plugs for the interfaces X101/X102 have similar cases, however internally the interlock wiring is different and therefore a differentiation must be made! Fig. 31 Interlock connection scheme for TC.GSS power supplies via the CAN cable and the related dummy plugs. 2011-10-18 60 / 298 V00.05b 4
<strong>Manual</strong> – TopCon TC.GSS Multi-unit system Internal system communication Interlock modules in accordance with Fig. 31 1 2 3 4 External EMERGENCY STOP button that can interrupt the interlock circuit. Dummy plug “X101; CAN TERM; Interlock CTR 4“ Is connected to interface X101 on the rear side so that the interlock circuit is not interrupted. (If there is no circuit -1-). Dummy plug: “X101 CAN TERM” Is connected to interface X102 on the rear side of the last device in the multi-unit system (if there is no circuit). Dummy plug “X105; Interlock CTR 4” Is connected to interface X105 on the rear side so that the interlock circuit is not interrupted. CAN cable connects interface X102 on the first device to the interface X101 on the following device. Table 25 Connection of dummy plugs to the related interfaces in the multi-unit system. 4.4.3.3. Multi-unit system with TopCon power supplies Master-slave principle on power supplies in the multi-unit system The set values are provided to the master device, e.g. via HMI or the PC using the TopControl application. The master device passes on the parameters to its slaves via the internal system communication. The individual slave devices in the multi-unit system convert the set values specified into the related output values. Limits of a multi-unit system Only one master is allowed per multi-unit system. Per multi-unit system at full bandwidth maximum number of devices: 7 (From 8 devices, the bandwidth can be reduced) Devices such as HMI or RCU also count in a multi-unit system. A device address is only allowed to occur once in the multi-unit system. Several multi-unit systems can be connected via a Multi-Rack Controller (MRC) to form a large multi-unit system. 2011-10-18 61 / 298 V00.05b 4
Page 1 and 2:
TC.GSS Grid-tie Source Sink Regatro
Page 3 and 4:
Manual - TopCon TC.GSS Manufacturer
Page 5 and 6:
Manual - TopCon TC.GSS Using the ma
Page 7 and 8:
Manual - TopCon TC.GSS Table of con
Page 9 and 10: Manual - TopCon TC.GSS General Tabl
Page 11 and 12: Manual - TopCon TC.GSS 1. Product d
Page 13 and 14: Manual - TopCon TC.GSS Mechanical d
Page 15 and 16: Manual - TopCon TC.GSS 1.6. Positio
Page 17 and 18: Manual - TopCon TC.GSS Position of
Page 19 and 20: Manual - TopCon TC.GSS 2. Safety Ge
Page 21 and 22: Manual - TopCon TC.GSS Categorisati
Page 25 and 26: Manual - TopCon TC.GSS 2.2.5. Trans
Page 29 and 30: Manual - TopCon TC.GSS Instructions
Page 31 and 32: Manual - TopCon TC.GSS Controls and
Page 33 and 34: Manual - TopCon TC.GSS 4.2. Operati
Page 35 and 36: Manual - TopCon TC.GSS Operating mo
Page 41 and 42: Manual - TopCon TC.GSS Single devic
Page 51 and 52: Manual - TopCon TC.GSS Device state
Page 57 and 58: Manual - TopCon TC.GSS Multi-unit s
Page 59: Manual - TopCon TC.GSS Multi-unit s
Page 69 and 70: Manual - TopCon TC.GSS 5. Options a
Page 71 and 72: Manual - TopCon TC.GSS 5.2. Hardwar
Page 73 and 74: Manual - TopCon TC.GSS CAUTION Opti
Page 75 and 76: Manual - TopCon TC.GSS Options and
Page 81 and 82: Manual - TopCon TC.GSS 5.3. Softwar
Page 85 and 86: Manual - TopCon TC.GSS The gradient
Page 95 and 96: Manual - TopCon TC.GSS 5.4.8. TC-Et
Page 105 and 106: Manual - TopCon TC.GSS Installation
Page 107 and 108: Manual - TopCon TC.GSS Cooling Inst
Page 109 and 110: Manual - TopCon TC.GSS 6.2. Commiss
Page 111 and 112:
Manual - TopCon TC.GSS Installation
Page 113 and 114:
Page 115 and 116:
Page 117 and 118:
Manual - TopCon TC.GSS 6.3.2.4. Fun
Page 119 and 120:
Manual - TopCon TC.GSS 7. Device op
Page 121 and 122:
Manual - TopCon TC.GSS Analogue int
Page 123 and 124:
Page 125 and 126:
Page 127 and 128:
Page 129 and 130:
Page 131 and 132:
Manual - TopCon TC.GSS 7.3. HMI and
Page 133 and 134:
Manual - TopCon TC.GSS Multi-unit s
Page 135 and 136:
Manual - TopCon TC.GSS 7.3.4.2. HMI
Page 137 and 138:
Manual - TopCon TC.GSS HMI and RCU
Page 139 and 140:
Manual - TopCon TC.GSS Operation of
Page 141 and 142:
Manual - TopCon TC.GSS System scree
Page 143 and 144:
Manual - TopCon TC.GSS System setti
Page 145 and 146:
Manual - TopCon TC.GSS CAUTION Oper
Page 147 and 148:
Page 149 and 150:
Page 151 and 152:
Page 153 and 154:
Manual - TopCon TC.GSS Limit settin
Page 155 and 156:
Manual - TopCon TC.GSS 7.3.5. Troub
Page 157 and 158:
Manual - TopCon TC.GSS 7.4. TopCont
Page 159 and 160:
Manual - TopCon TC.GSS No CD-ROM dr
Page 161 and 162:
Page 163 and 164:
Manual - TopCon TC.GSS TopControl -
Page 165 and 166:
Manual - TopCon TC.GSS TopControl a
Page 167 and 168:
Page 169 and 170:
Manual - TopCon TC.GSS 7.4.7.2. Men
Page 171 and 172:
Manual - TopCon TC.GSS Setting the
Page 173 and 174:
Manual - TopCon TC.GSS 7.4.7.3. Men
Page 175 and 176:
Manual - TopCon TC.GSS 7.4.8.1. Tab
Page 177 and 178:
Page 179 and 180:
Page 181 and 182:
Page 183 and 184:
Page 185 and 186:
Page 187 and 188:
Page 189 and 190:
Manual - TopCon TC.GSS Manual trigg
Page 191 and 192:
Page 193 and 194:
Page 195 and 196:
Page 197 and 198:
Manual - TopCon TC.GSS Creating AAP
Page 199 and 200:
Page 201 and 202:
Manual - TopCon TC.GSS Scope displa
Page 203 and 204:
Manual - TopCon TC.GSS 4 TopControl
Page 205 and 206:
Manual - TopCon TC.GSS 8 7 6 TopCon
Page 207 and 208:
Manual - TopCon TC.GSS “Select si
Page 209 and 210:
Page 211 and 212:
Page 213 and 214:
Manual - TopCon TC.GSS Control grou
Page 215 and 216:
Page 217 and 218:
Page 219 and 220:
Page 221 and 222:
Page 223 and 224:
Page 225 and 226:
Page 227 and 228:
Page 229 and 230:
Page 231 and 232:
Manual - TopCon TC.GSS CAUTION 7.4.
Page 233 and 234:
Page 235 and 236:
Page 237 and 238:
Manual - TopCon TC.GSS Parameter li
Page 239 and 240:
Manual - TopCon TC.GSS Filtering an
Page 241 and 242:
Manual - TopCon TC.GSS Handling gri
Page 243 and 244:
Manual - TopCon TC.GSS 7.4.8.11. Ta
Page 245 and 246:
Page 247 and 248:
Manual - TopCon TC.GSS 7.4.8.12. Ta
Page 249 and 250:
Manual - TopCon TC.GSS 8. Maintenan
Page 251 and 252:
Page 253 and 254:
Manual - TopCon TC.GSS System infor
Page 255 and 256:
Manual - TopCon TC.GSS Device hardw
Page 257 and 258:
Manual - TopCon TC.GSS Support Prod
Page 259 and 260:
Manual - TopCon TC.GSS 9.6. Device
Page 261 and 262:
Manual - TopCon TC.GSS Support Disp
Page 263 and 264:
Manual - TopCon TC.GSS 10.1.2. Leak
Page 265 and 266:
Manual - TopCon TC.GSS Times Starti
Page 267 and 268:
Manual - TopCon TC.GSS Appendix Tec
Page 269 and 270:
Page 271 and 272:
Page 273 and 274:
Page 275 and 276:
Manual - TopCon TC.GSS 10.2. Error
Page 277 and 278:
Manual - TopCon TC.GSS Appendix Err
Page 279 and 280:
Page 281 and 282:
Page 283 and 284:
Page 285 and 286:
Page 287 and 288:
Page 289 and 290:
Page 291 and 292:
Manual - TopCon TC.GSS Group error:
Page 293 and 294:
Page 295 and 296:
Manual - TopCon TC.GSS TCP_Certific
Page 297 and 298:
Manual - TopCon TC.GSS 11. Index an
show all

Manual

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?